Full metadata record
DC pole | Hodnota | Jazyk |
---|---|---|
dc.contributor.author | Puntambekar, Nirant V. | |
dc.contributor.author | Jablokow, Andrei G. | |
dc.contributor.editor | Skala, Václav | |
dc.date.accessioned | 2015-09-22T13:10:47Z | |
dc.date.available | 2015-09-22T13:10:47Z | |
dc.date.issued | 1998 | |
dc.identifier.citation | Journal of WSCG. 1998, vol. 6, no. 1-3, p. 510-516. | en |
dc.identifier.issn | 1213-6972 (print) | |
dc.identifier.issn | 1213-6980 (CD-ROM) | |
dc.identifier.issn | 1213-6964 (online) | |
dc.identifier.uri | http://hdl.handle.net/11025/15863 | |
dc.identifier.uri | http://wscg.zcu.cz/wscg1998/wscg98.htm | |
dc.format | 7 s. | cs |
dc.format.mimetype | application/pdf | |
dc.language.iso | en | en |
dc.publisher | Václav Skala - UNION Agency | cs |
dc.relation.ispartofseries | Journal of WSCG | en |
dc.rights | © Václav Skala - UNION Agency | cs |
dc.subject | geometrické modelování | cs |
dc.subject | povrchová montáž | cs |
dc.subject | drážkování | cs |
dc.title | Selection of the number of control points for spline surface approximation | en |
dc.type | článek | cs |
dc.type | article | en |
dc.rights.access | openAccess | en |
dc.type.version | publishedVersion | en |
dc.description.abstract-translated | Parametric spline surfaces represent an important surface type in the process of reverse engineering. Various surface fitting techniques are available for fitting of splines to sets of data points, here we consider a least squares fitting technique. A user input to this algorithm is the number of control points to be used for the fitting in the two parametric directions. Using a larger number of points, gives a more accurate fitted surface but also results in a surface with a number of undulations or surface wiggles which may not be desired. This paper is concerned with the optimal selection of the number of control points to be used for the least squares surface fitting of B spline surface patches. An optimal method based on multicriteria optimization is presented do decide on the number of control points to be used in the fitting. | en |
dc.subject.translated | geometric modelling | en |
dc.subject.translated | surface fitting | en |
dc.subject.translated | splines | en |
dc.type.status | Peer-reviewed | en |
Vyskytuje se v kolekcích: | Volume 6, number 1-3 (1998) |
Soubory připojené k záznamu:
Soubor | Popis | Velikost | Formát | |
---|---|---|---|---|
Puntambekar_98.pdf | Plný text | 882 kB | Adobe PDF | Zobrazit/otevřít |
Použijte tento identifikátor k citaci nebo jako odkaz na tento záznam:
http://hdl.handle.net/11025/15863
Všechny záznamy v DSpace jsou chráněny autorskými právy, všechna práva vyhrazena.