Název:	Characterisation of Polyurethane Potting Compounds with Semiconductive Coating for Explosive Atmosphere Applications
Autoři:	Kalaš, David Kadlec, Petr Pretl, Silvan Soukup, Radek Polanský, Radek
Citace zdrojového dokumentu:	KALAŠ, D. KADLEC, P. PRETL, S. SOUKUP, R. POLANSKÝ, R. Characterisation of Polyurethane Potting Compounds with Semiconductive Coating for Explosive Atmosphere Applications. In Proceedings of the 2022 9th International Conference on Condition Monitoring and Diagnosis (CMD). Piscataway: IEEE, 2022. s. 471-474. ISBN: 978-4-88686-431-4
Datum vydání:	2022
Nakladatel:	IEEE
Typ dokumentu:	konferenční příspěvek ConferenceObject
URI:	http://hdl.handle.net/11025/50947
ISBN:	978-4-88686-431-4
Klíčová slova v dalším jazyce:	polyurethane potting compounds;semiconductive coating;surface resistivity;wetting effect;thermal stress
Abstrakt v dalším jazyce:	Electronic devices intended for an explosive atmosphere with a significant concentration of explosive gases, vapours, or dust, must meet strict standards requirements. The essential requirement is low surface resistivity, vital for dissipating static charge from the environment and preventing spark generation. This paper is focused on the dielectric characterisation of three variants of electrical insulating polyurethane potting compounds in combination with three dissipative coatings. The analysis of the specimen's surface resistivity in the (i) initial state, (ii) state after their placement in a water bath, (iii) state after their placement in a water bath with detergent, and (iv) state after thermal stabilisation in an air oven at 125 °C was performed. Then, the effect of such conditions on the dielectric properties of tested specimens with/without different coatings was assessed. It was found that the surface resistivity is significantly affected for all tested specimens by immersion in water. Nevertheless, after a long-term stabilisation under ambient conditions, the surface resistivity of the specimens with/without coatings was close to the values before immersion for two types of coating. For the third type, a different trend in the observed parameters was found for two combinations of polyurethane compound and semiconductive coating due to the lower adhesion of these materials, which had an impact on the stability of the coating.
Práva:	Plný text je přístupný v rámci univerzity přihlášeným uživatelům. © IEEE
Vyskytuje se v kolekcích:	Konferenční příspěvky / Conference Papers (KET) Konferenční příspěvky / Conference papers (RICE) OBD

Všechny záznamy v DSpace jsou chráněny autorskými právy, všechna práva vyhrazena.