Modelování a monitorování lidského těla / Human body modelling and monitoring (MLT)


Recent Submissions

Bellemore, M.
Experience with the Intramedullary Skeletal Kinetic Distractor for Limb Lengthening (ISKD Nail)

Hromádka, Aleš , Jiřičková, Jana , Martínek, Zbyněk , Sirový, Martin
Operation assessment of cogeneration power plant by thermodynamic model

SfePy (simple finite elements in Python) is a software for solving various kinds of problems described by partial differential equations in one, two, or three spatial dimensions by the finite element method. Its source code is mostly (85%) Python and relies on fast vectorized ...

Tolar, David , Štork, Milan
Monitoring of a skin temperature in vicinity of a surgical wound

This article describes experimental measurements of a skin temperature in vicinity of a surgical wound. Measurements were carried out in collaboration with the orthopedic department of the University Hospital Olomouc, Czech Republic. A system used for sensing, transmission and visualization of&#x...

Sánchez-Alvarado, A. , Sánchez-Brenes, O. , Sánchez-Brenes, M. , Zerpa- Catanho, M. , Vargas-Del Valle, C. , Céspedes-Calderón, G.
Intra- and inter-somatotype differences in a manual material handling task

The Manual Material Handling (MMH) of loads is considered worldwide one of the main components in musculoskeletal disorders in various industries, which also carries a high cost. Prior research has shown that there are limited studies comparing different bodily characteristics for both ...

Lyu, W. , Bońkowski, T. , Hynčík, L.
Development of a simple helmet finite element model

The developed helmet is tested for 8 impact configurations (4 impact directions for both anvils). The ECE R22.05 regulation [9] defines, that the maximum acceleration must not exceed 275 g and the maximum HIC must not exceed 2400 for each impact and the helmet fulfils the...