Název:	FE Simulation of Hot Single Point Incremental Forming Assisted by Induction Heating
Autoři:	Al-Obaidi, Amar Kräusel, Verena Kroll, Martin
Citace zdrojového dokumentu:	Proceeding of UIE 2021: XIX International UIE Congress on Evolution and New Trends in Electrothermal Processes. 1.-3.2021, Pilsen, Faculty of Electrical Engineering, University of West Bohemia, Czech Republic, 2021, p. 47-48.
Datum vydání:	2021
Nakladatel:	Faculty of Electrical Engineering, University of West Bohemia
Typ dokumentu:	konferenční příspěvek conferenceObject
URI:	http://hdl.handle.net/11025/45782
ISBN:	978-80-261-0930-3
Klíčová slova:	indukční ohřev;jednobodový přírůstkový formování;vysokopevnostní ocel;FE modelování
Klíčová slova v dalším jazyce:	induction heating;single point incremental forming;high strength steel;FE modeling
Abstrakt v dalším jazyce:	Single Point Incremental Forming (SPIF) of high-strength is challenging. It requires high forming-forces, also the materials exhibit relatively low formability and distinctive springback behavior. Consequently the forming process is limited and the geometrical accuracy is decreased. Therefore hot SPIF was introduced. In the present study, with induction assisted locally heated single point incremental forming (IASPIF) a variant of this approach is investigated. This process was accomplished by forming on the upper side of the sheet using the forming tool while the heat was generated by a circular heating disc moving on the lower side of the sheet. The heat was transferred from the heating disc to the sheet during forming. The sheet was heated locally by this method, in which the heating disc was following the forming tool, by applying the same path for both of them.
Práva:	© IEEE
Vyskytuje se v kolekcích:	UIE 2021 UIE 2021

Všechny záznamy v DSpace jsou chráněny autorskými právy, všechna práva vyhrazena.