Fakulta strojní / Faculty of Mechanical Engineering

Zobrazit statistiky

Podkomunity


Poslední příspěvky

Hůlka, Petr
Návrh funkčního P&ID strojovny průmyslové parní turbíny 40MW s teplofikací se zaměřením na uzavřený chladicí okruh

This Master thesis is focused on creation of P&ID for machine room of 40WM industrial steam turbine for heating industry. In the machine room there are low-pressure and high-pressure heaters (LPH & HPH) and 2 district water heaters. The P&ID shows pipelines, valves and&...

Elmanová, Andrea
Vliv interkritického tepelného zpracování na mechanické vlastnosti a mikrostrukturu oceli 1.4107

The diploma thesis deals with the influence valuation of gradual repetition of different cycles during cast steel heat treatment for the production of high pressure body of steam turbines. These cycles should simulate the impact of possible repeated heat treatment after welding.The...

Palán, Marek
Oprava primárního kolektoru parního generátoru JE typu VVER 440MW svařováním

The thesis is concerned with the issues of repairing damaged heads of primary collectors of steam generators. In the exordium a current technology of repairing, which consists of replacement of head of primary collector performed by manual way through welding with methods 141 and&#...

Kubík, Martin
Analýza a hodnocení nového montážního postupu vřeteníku HCW2 ve společnosti Škoda Machine Tool, a.s.

The thesis is focused on solving assembly procedures in the company Škoda Machine Tool, a.s. The thesis analyzes the current state of creation of assembly procedures in the company. The main aim of this thesis is to create the assembly procedure of assembly groups headstock&#x...

Ruda, Pavel
Vliv řezného materiálu na povrchové vlastnosti obrobené plochy u materiálu Inconel 718

The main aim of Thesis is introduction with HRSA and defects in the surface layer of the machined surface. The main goal is to find suitable cutting materials for finishing technology of turning operation with respect to the defects in the machined surface.