Disertační práce / Dissertations (KET) Domovská stránka kolekce Zobrazit statistiky
Krpal, Ondřej
Komplexní studie polovodivých ochran The dissertation deals with the new approaches in the design of semiconductive protection (the EGS protection) in high-voltage rotating machines. These protections are applied to the stator bars in the end-winding of the generator and are electrically stressed during the machine operation,... |
||
Just, Eva
Řízení technologických procesů z hlediska kvality The dissertation thesis result is the design of methodology for process control of input quality for purchased parts in non-series production and the verification of its benefits. This methodology proposal is also based on methods used in mass production lines, but these cannot be&... |
||
Kroupa, Michael
Perspektivní elektronické součástky This paper deals with the organic materials and their use in electronic components. The main part is focused on organic sensors for detection of chemical substances and sensor response processing. The first part describes electronic components where the organic materials are used. The... |
||
Dončuk, Jan
On-line diagnostika transformátorů Monitoring of power transformers is a perspective way how to gather information about the actual condition of the power transformer critical components during operation. The submitted dissertation thesis is mainly focused on improvement of reliability, plausibility and utilization of information ... |
||
Sýkora, Martin
Elektroakustika v multimediálních a ozvučovacích systémech The main goals of this thesis are to explain possibilities of acoustic measurement with music signal. Main part of the thesis deals with searching specific fragments in music signal and development measurement methods, which use founded fragments to obtain some acoustic parameters. In... |
||
Mráz, Petr
Analýza a záznam výbojové činnosti v elektrických zařízeních This doctoral thesis deals with measurement and evaluation of discharge mechanisms in electrical devices, especially by using a method of measuring partial discharges in devices with winding. It focuses on both measured and derived parameters of partial discharges designated for evaluation o... |
||
Novák, Tomáš
Materiály a technologie pro propojovací (kontaktní) struktury This thesis deals with interconnection in electronics, focusing on the structure and properties of solder joints. Brief description of materials and technologies mostly used for interconnection in electronics is in the introduction. These are soldering and bonding technology of surface finishes... |
- DSpace at University of West Bohemia
- Publikační činnost / Publications
- Fakulta elektrotechnická / Faculty of Electrical Engineering
- Katedra technologií a měření / Department of Technologies and Measurement